Yamaha engine interface cable 4.5 m (15 ft) and T-connector
Yamaha Engine Interface Cable
Connects to Yamaha engines without Yamaha CommandLink Plus system.
| Yamaha | 4-stroke 50-250| 2-stroke HDPI 150-350| |
| RPM | Yes| Yes |
| Alternator Voltage | Yes| Yes |
| Engine Hours | Yes| Yes |
| Engine Temperature | Yes| Yes |
| Fuel Pressure | Yes| Yes |
| Fuel Rate | Yes| Yes |
| Oil Pressure | Yes| Yes |
| Trim * | Yes| Yes |
| Water Pressure | Yes| Yes |
*Requires NMEA 2000 network. Kit includes T-connector to connect to a new or existing NMEA 2000 network. Add NMEA 2000 starter kit, part number 000-0124-69, if a network is not already installed.
The MiniPlex-BUF is an advanced NMEA buffer/splitter featuring one input and seven outputs.
New low loss NMEA2000 4-way joiner. Connect four NMEA2000 Micro-C devices to the NMEA2000 Network.This replaces 000-10996-001
The MR-208 a fully programmable 2-lnput/8-Output NMEA Buffer that can be used on a plethora of applications and meet even the most exacting installation standards.
20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)
Ethernet adapter cable, RJ45 F to 5 Pin male, 1.5 m (4.9 ft). Ships with water proof boot.
Micro-C female to SimNet 1.0 m (3.2 ft) cable that connects a NMEA 2000® product to a SimNet backbone
N2K-T-RD - Micro-C T-connector for connection of an additional network device
Ethernet Cable -Yellow 5-Pin Male-Male - 1.8 m (6 ft)
NEP-2 Network Expansion Port enables multiple displays to exchange chart data, waypoint and route information, as well as interconnecting radar and echosounder modules.
NMEA 2000 Micro-C Medium duty cable. 6 m (19.7 ft) Low loss 18 gauge cable recommended for network backbone runs
N2KEXT-15RD - 4.55 m (15-ft) NMEA 2000® cable for backbone extension or or drop cable to connect an additional network device
NMEA 0183® - NMEA 2000® converter. 1.8 m (6 ft) Micro-C to bare wire cable
Ελληνικά
Español
