Fuel Flow Sensor - For gasoline engines. In-line sensor for 3/8" (9.5 mm) Inside Diameter fuel line. Comes with 10ft cable and T-connector.
Outputs:
| Cable Length | 10 Ft |
| Fuel Line Diameter | 3/8" (9.5 mm) Inside Diameter |
| Flow Rate Measured | Optimized for 0.6-45 Gal/hr but can measure outside these values |
| Added Back Pressure to the fuel system | 0.5 PSI at 20 Gal/hr; 1 PSI at 40 Gal/hr |
| Installation Location | Above the max level of the fuel tank, in-line after the fuel filter and any Y's or T's in the line |
| Package contents | Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps |
| Fuel Type | Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel systems. |
| Hole required to route through a bulkhead | 22mm (7/8") |
| Multiple Fuel Flow sensors possible | Yes |
Specifications:
| Cable Length | 10 Ft |
| Fuel Line Diameter | 3/8" (9.5 mm) Inside Diameter |
| Flow Rate Measured | Optimized for 0.6-45 Gal/hr but can measure outside these values |
| Added Back Pressure to the fuel system | 0.5 PSI at 20 Gal/hr; 1 PSI at 40 Gal/hr |
| Installation Location | Above the max level of the fuel tank, in-line after the fuel filter and any Y's or T's in the line |
| Package | The Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps |
| Fuel Type | Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel systems, or on any fuel system with a return line or sump. |
| Hole required to route through a bulkhead | 22mm (7/8") |
| Multiple Fuel Flow Sensors possible | Yes |
SimNet to Micro-C (male) cable that connects a SimNet product to a NMEA 2000® backbone 0.5 m (1.6 ft)
The MiniPlex-3 Series NMEA multiplexers comprises a range of advanced NMEA multiplexers which combines data from multiple navigation instruments.
SimNet power cable with terminator 2 m (6.6 ft) - red tip
NMEA 2000 Micro-C Medium duty cable. 10 m (33 ft) Low loss 18 gauge cable recommended for network backbone runs
Ethernet Cable -Yellow 5-Pin Male-Male - 7.6 m (25 ft)
N2KEXT-25RD - 7.58 m (25-ft) NMEA 2000® cable for network backbone extension only
20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)
Adapter cable: Ethernet yellow 5 pin male to RJ45 female, 2m (6.5ft)
Evinrude engine interface cable 4.5 m (15 ft) and T-connector
N2KEXT-15RD - 4.55 m (15-ft) NMEA 2000® cable for backbone extension or or drop cable to connect an additional network device
Fluid Level Sensor - Connects to a standard suitable tank level sensor and transmits the tank level on the the NMEA 2000 network.
N2KEXT-2RD - 0.61 m (2-ft) NMEA 2000® cable for backbone extension or drop cable to connect an additional network device
Ethernet Cable -Yellow 5-Pin Male-Male - 1.8 m (6 ft)
NMEA2000 Micro-C Medium duty cable. 2 m (6.5 ft). Low loss 18 gauge cable recommended for network backbone runs
Ελληνικά
Español
